Gaia Portal editing bond interface Operation Mode is invisible on Jumbo Hotfix R81.20 Take 43

Product: Check Point Appliances
Version: R81.20
Last Modified: 2024-08-19

Symptoms

• Under Gaia Web Portal > Network Management > Network Interfaces > Bond interface > Edit, the "Operation Mode" options are invisible after installing Jumbo Hotfix Accumulator R81.20 Take 43 or higher.

Cause

The Operation Mode options are currently not visible because the panel height was previously reduced.

Solution

This problem was fixed. The fix is included in:

• Jumbo Hotfix Accumulator for R81.20 starting from Take 79

If you choose not to upgrade, this workaround is available:

Use the clish command to configure the bond interface mode. For example,

clish >  set bonding group <bond-ID> mode <option>
clish > save config

NOTE

This solution has been verified for the specific scenario, described by the combination of Product, Version and Symptoms. It may not work in other scenarios.

Article Properties

Access Level: General
Status: Approved by TAC
Date Created: 2024-07-02
Last Modified: 2024-08-19