# Gaia Portal editing bond interface Operation Mode is invisible on Jumbo Hotfix R81.20 Take 43

**Product**: Check Point Appliances  
**Version**: R81.20  
**Last Modified**: 2024-08-19

## Symptoms

- Under Gaia Web Portal > Network Management > Network Interfaces > Bond interface > Edit, the "Operation Mode" options are invisible after installing Jumbo Hotfix Accumulator R81.20 Take 43 or higher.

## Cause

The Operation Mode options are currently not visible because the panel height was previously reduced.

## Solution

This problem was fixed. The fix is included in:

- [Jumbo Hotfix Accumulator for R81.20](https://sc1.checkpoint.com/documents/Jumbo_HFA/R81.20/Default.htm) starting from Take 79

If you choose not to upgrade, this **workaround** is available:

Use the clish command to configure the bond interface mode. For example,

```
clish >  set bonding group <bond-ID> mode <option>
clish > save config
```

#### NOTE

This solution has been verified for the specific scenario, described by the combination of Product, Version and Symptoms. It may not work in other scenarios.

## Article Properties

**Access Level**: General  
**Status**: Approved by TAC  
**Date Created**: 2024-07-02  
**Last Modified**: 2024-08-19